Visonic POWERMASTER-10 - INSTALLER GUIDE Spécifications télécharger pdf (Page 70)

D-302756 69

See the table below for a complete list of possible LAN messages.

∗ If there are no wireless devices enrolled in the PowerMaster-10

system, the PowerMaster-10 display reads "

NO DEVICES

** When the button is pressed the test result takes up to 4 min.

before it is displayed, depending on the severity of the failure.

Pressing the or buttons at any stage in the procedure

will take you to “

<OK> TO EXIT

” or pressing the

button at the

end of the procedure will take you to the "

LAN RESET OPTION

" menu.

The following LAN messages are reported:

Message Description

Unit is ok PowerLink Broadband Module is functioning correctly.

Test aborted The diagnostic test is aborted, as follows:

• AC failure – PowerLink Broadband Module is set to OFF mode.

• PowerLink Broadband Module has not completed the power-up procedure. In

this case, the installer should wait a maximum of 30 seconds before re-

testing.

Comm. loss The RS-232 serial interface between the PowerLink Broadband Module and the

PowerMaster-10 failed.

Rcvr Ip missing Receivers IP 1 and 2 settings are missing in the PowerMaster-10.

Cable unplugged The Ethernet cable is not connected to the PowerLink Broadband Module.

Check lan config This message appears in any of the following cases:

• Incorrect PowerLink Broadband Module IP has been entered.

• Incorrect subnet mask has been entered.

• Incorrect default gateway has been entered.

• DHCP server failure.

Rcvr#1 UnReach.

Rcvr#2 UnReach.

Receiver 1 or 2 is inaccessible, as follows:

• Wrong receiver IP has been entered.

• Receiver failure.

• WAN Network failure.

Rcvr#1 UnReg.

Rcvr#2 UnReg.

The PowerMaster-10 unit is not registered to IP receiver 1 or 2.

Broadband Module timeout

err.

PowerLink Broadband Module does not respond to test result within 70 sec.

Invalid result PowerLink Broadband Module responds with a result code that is not recognized

by the PowerMaster-10.

5.1.7 LAN Reset Option

Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".

REBOOT

LAN RESET OPTION

WL DEVICES

DIAGNOSTICS

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 85 86

Commentaires sur ces manuels

Pas de commentaire

Visonic POWERMASTER-10 - INSTALLER GUIDE Spécifications Page 70

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Visonic POWERMASTER-10 - INSTALLER GUIDE