Visonic POWERMASTER-10 - INSTALLER GUIDE Spécifications télécharger pdf (Page 62)

D-302756 61

B. To Configure PGM Lighting Devices in Alarm Conditions and To Set Daytime Limits of Lighting Devices

Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".

Select between "no flash" and "all light flash".

10.

Enter the time at which you wish the lockout state to begin (usually at

dawn).

Note: AM and PM are selected by pressing

and ,

respectively.

11.

12.

13.

Enter the time at which you wish the lockout state to end (usually in the

evening).

Note: AM and PM are selected by pressing

and ,

respectively.

14.

Pressing the or buttons at any stage in the procedure

will take you to “

<OK> TO EXIT

”.

stop – HH:MM

TIME 07:00P

stop – HH:MM

start – HH:MM

FLASH ON ALARM

TIME 07:00A

start – HH:MM

LOCKOUT TIME

no flash



PGM: GENERAL DEF

DEFINE PGM

DEFINE OUTPUTS

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 85 86

Pas de commentaire

Visonic POWERMASTER-10 - INSTALLER GUIDE Spécifications Page 62