Visonic PowerLink2 Guide de l'utilisateur télécharger pdf (Page 14)

Installing the Visonic PowerLink2

Programming for Configuring Events Reporting to Central Stations

Follow the instructions below to select the type of events to be reported and to

determine the method used for reporting events.

1. From the PowerMax control panel, enter "INSTALLER MODE" menu using the

Installer Code.

2. Enter the "5.DEFINE COMM." menu.

3. Enter the "3:C.S.REPORTING" sub-menu.

4. Program the following menus:

• "REPORT EVENTS" – Select the type of events that the control panel will

report to the Central Station.

• "1

REPORT METHOD" – Define the 1

priority of method used

to report events. Select the "broadband" option for PowerLink2.

• "IP RCVR 1/2" – Enter the Central Station IP address the PowerLink2 will

report to (not mandatory field).

Router Configuration

After installing the hardware you need to configure the Home Router. Different Home

Router models have different login interfaces and configuration. The following

section includes a general description of the procedure and an example of a specific

Home Router model. Router specific instructions and guides for port forwarding can

be found at http://www.portforward.com.

Step 1: Determining the IP Addresses of Home Router and Visonic

PowerLink2

1. Make sure you have in front of you the Visonic PowerLink2 Installation Form

- see appendix B.

2. On your PC click Start > Run.

3. In the Open text box type cmd and click OK.

4. At the Command Prompt type ipconfig and press Enter

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 65 66

Pas de commentaire

Visonic PowerLink2 Guide de l'utilisateur Page 14